How to set the appliance for surface cooking, Hot surface indicator, Cooking areas – Samsung FE-R300SB User Manual

Page 17

Advertising
background image

02

SURF

ACE COOKING

Surface cooking _

17

Location of the radiant surface elements and controls

The radiant control knobs operate the radiant surface elements on the cooktop as shown below.

Dual

Left Front

Element

Single

Left Rear

Element

Single

Right Rear

Element

Dual

Right front

Element

Hot surface indicator

Comes on when the unit is turned on or hot to the touch.

Stays on even after the unit is turned off.

Glows until the unit is cooled to approximately 150°F.

Cooking areas

The cooking areas on your range are identified by permanent circles on the glass cooking

surface. For the most efficient cooking, fit the pan size to the element size.

Pans should not extend more than ½” to 1” beyond the cooking area.

When a control is turned on, a glow can be seen through the glass cooking surface.

The

element will cycle on and off to maintain the preset heat setting, even at high settings.

For more information on selecting proper types of cookware, refer to the section “Using the

proper cookware” on page 18.

hoW to Set the APPliAnce for SurfAce cookinG

The surface elements may be hot and burns may occur. Do not touch surface

elements until they have cooled down sufficiently.

At high or medium-high settings, never leave food unattended. Boilovers cause

smoking and greasy spillovers may catch on fire.

Be sure you turn the control knob to

OFF when you finish cooking.

The area between the high and off settings, are not appropriate for cooking.

Single surface unit control knob (left rear, right rear)

1. Push the knob in.
2. Turn in either direction to the setting you want.

At both the off and high settings, the knob clicks into position.

FE-R300_XAA DG68-00277A.indd 17

2010-01-20 �� 12:09:46

Advertising