Samsung 2.1CH BLU-RAY HT-BD8200 - Manual (Page 20)

20
Connections
This section involves various methods of connecting the Blu-ray Home Theater to other external components.
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly)
automatically when turned on. If the link indicator does not light when main unit and subwoofer are turned on,
please set the ID by following the process below.
1. Plug the power cords of the main unit and subwoofer into the AC power supply.
2. Press the ID SET button on the back of the subwoofer with a small, pointed object for 3
seconds.
The STANDBY indicator is turned off and the LINK indicator (blue LED) blinks quickly.
3. In stand-by mode while the main unit is off, press the
0, 1, 3, 5 buttons in order.
The main unit's red stand-by LED fl ashes white and
turns red again.
4. Press the POWER button to turn on the main unit.
The main unit and the subwoofer are now linked
(connected).
The Link indicator (blue LED) on the subwoofer is turned on.
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the
STANDBY LED on the upper side will blink.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any
other device that uses the same frequency (2.4GHz) near the system, some sound interruption
may be heard due to interference.
The transmission distance of the wireless signal between the main unit and sub is about 33 ft.,
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between main unit and the wireless subwoofer, the system may not operate at all, because the
wireless signal cannot penetrate metal.
If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the connection
between the main unit and wireless subwoofer.
•
•
•
•
M
▪
▪
▪
▪
▪
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
▪
▪
<The rear of the Subwoofer> <The top of the Subwoofer>
HT-BD8200_XAA_0724-1.indd 20 HT-BD8200_XAA_0724-1.indd 20 2009-07-24 11:09:56 2009-07-24 11:09:56