Installing the wall mount, Installing the cradle stand, Connecting – Samsung 2.1CH BLU-RAY HT-BD8200 User Manual

Page 21

Advertising
background image

21

ENG

CONNECTIONS

INSTALLING THE WALL MOUNT

1. Disconnect the cradle stand from the unit.

2. Peel off the fi lm from the double-sided adhesive sheet

for the wall mount and attach it on a clean wall.

3. Secure the wall mount bracket using 6 screws (not

supplied) while aligning holes marked on the sheet.

4. Attach the back unit bracket(bracket set mount) with

the Home Theater unit by fastening provided 4 screws.

5.

Fully insert the back bracket’s clasp into
the wall mount bracket’s receptacle and
fi x it by fully sliding to the right.

Installation completed.

Do not hang onto the installed unit and avoid any impact to the unit.
Secure the unit fi rmly to the wall so that it does not fall off. If the unit falls off, it may result in an
injury or damage to the product.
When the unit is installed on a wall, please make sure that a child does not pull any of
connecting cables, as it may cause it to fall.

M


Do not install on a place other than a vertical wall.
When installating, avoid locations with high temperature or humidity, or a wall that cannot
sustain the weight of the set.
Check the strength of the wall. If the strength of the wall is insuffi cient for the product
installation, make sure to reinforce the wall before the installation.
Check the material of the wall. If the wall is made of plaster board, marble, or iron board,
purchase and use the appropriate fi xing screws.
Cables connecting to external devices are to be connected to the unit before installing.
Be sure to turn off the unit before installation. Otherwise, it may cause electric shock.
Do not turn the assembled cradle stand and main unit upside down, as the main unit may fall
from the stand and cause product damage or personal injury.

INSTALLING THE CRADLE STAND

You can use the cradle stand to install this unit on a shelf. Make sure you place the unit on a fl at surface.

Connecting

Face the FRONT mark on the stand forward and slide the
stand into the bottom of the unit until you hear a click.

HT-BD8200_XAA_0724-1.indd 21

HT-BD8200_XAA_0724-1.indd 21

2009-07-24 11:09:57

2009-07-24 11:09:57

Advertising