Smeg PTS605NU3 - Manual (Page 6)

Instructions for the user
8
3. USING THE COOKTOP
WARNING
FIRE HAZARD
FOR YOUR SAFETY:
- Do not allow the burner flame to extend beyond the
edge of the pan.
- Turn off all controls when not cooking.
NOTE: Check that the fixing rings, burners, flame diffuser rings and pan
stands are fitted correctly. The burner pins A must be fitted into the
recesses B in the flame diffuser ring. The holes C in the flame diffuser
ring must mate with the ignition plugs and thermocouples D on the
cooktop.
3.1 Ignition with safety device
Each knob has a symbol that shows the corresponding burner (the example here on the left shows the
front left burner).
The appliance is equipped with an electronic ignition.
- Just press and simultaneously turn the knob counter-clockwise to the minimum flame symbol until
the burner switches on.
- Keep the knob pressed down for about 2 seconds to keep the flame lit and to activate the safety
device.
- After switching the burner on it is recommended that the knob be left in the minimum position for
approximately 20 seconds before adjusting it to the desired temperature.
It may happen that the flame goes out when the knob is released. In this case repeat the operation, but
keeping the knob pressed down for a longer time.
NOTE: If the flame goes out accidentally, after about 20 seconds the safety device will intervene and
block the gas flow, even when the valve is open.
REMEMBER: When the cooktop is in use, the entire cooktop area may become hot