Simplicity 11HP - Manual (Page 33)

27
Adjustments
Figure 32. Dash Controls (shown with steering wheel
removed)
A. Mower Lift Lever D. Clutch/Brake Pedal
B. Parking Brake Knob E. Dial-A-Cut TM Control
C. Ground Speed Lever F. Steering Shaft
*2394
6. See figure 31. On left side of mower, make sure
eccentric nut is in correct position as shown. Loosen
outside nut (A) and rotate eccentric nut (B) so that flat
side with hole closest to it is towards the rear. Tighten
ouside nut (A) while holding eccentric nut (B).
7. On right side of mower, loosen outside nut (A). Turn
eccentric nut (B) counterclockwise to raise side of
mower, or clockwise to lower right hand side of
mower.
NOTE: Do not turn eccentric nut more than 1/4 turn in
either direction. When adjusted beyond 1/4 turn, nut will
move mower in opposite direction than when starting
adjustment.
8. When adjustment is correct, hold eccentric nut (B)
and tighten nut (A) to 30 ft. lbs. Check measurement
on both sides of mower.
Figure 31. Leveling The Mower Side-to-Side
A. Nut
B. Eccentric Nut
C. Rear Rollers
*2399
F