Sunbeam 2576 - Manual (Page 3)

OPERATION MAINTENANCE
Plug the cord into any standard household electrical
outlet. (See data label for electrical specifications and
power consumption. This data label can be seen when
the cabinet top is removed.)
Turn the unit on by sliding the ON/OFF switch to the
desired speed: “DAILY USE, MEDIUM or HIGH”. (Fig-
ure 4) The air cleaner should be set on HIGH for 1
minute before switching to desired speed to initially
start-up the unit. Your air cleaner is designed for con-
tinuous operation
-- peak efficiency is obtained when
the air cleaner remains on constantly. For best results,
select “DAILY USE” setting.
An operating light is located on the top right front grill
and indicates that the unit is operating. (Figure 5)
Figure 4
O P E R A T I N G
L I G H T
Figure 5
CARE OF CABINET
You should treat the cabinet of your air cleaner as you
would any other piece of fine furniture. A soft, damp
cloth will keep it clean and attractive for many years.
The front grill can be cleaned using a vacuum cleaner
with a brush attachment.
TO REMOVE HEPA FILTER ASSEMBLY
Turn off the air cleaner and unplug it from the electri-
cal power source.
Remove the cabinet top by lifting up and remove the
Sealing Label (enables 99.97% efficiency) from the top
of the HEPA Filter Assembly.
Do not discard Sealing
Label. Lift out the collector assembly using the flip-up
handle. (Figure 6)
The HEPA Filter Assembly includes:
Aluminum Pre-Filter, HEPA Filter and Charcoal
After-Filter.
The front filter (Aluminum) is the Pre-Filter. The HEPA
Filter is the middle (large) filter, and the Charcoal After-
Filter is in the back of the HEPA Filter Assembly. (Fig-
ure 7)
Figure 6
C H A R C O A L
AFTER-FILTER
HEPA
FILTER
ALUMINUM
PRE-FILTER
HEPA
, FILTER
ASSEMBLY
Figure 7