Siemens Gigaset C34 - Manual (Page 17)

16
Appendix
Gigaset C34 / ISR eng / A31008-M1607-B501-1-7619 / start_guide_time.fm / 22.3.05
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us any time
at www.siemens.com/gigasetcustomer-
care. The table below contains a list of
common problems and possible solutions.
Service (Customer Care)
We offer you support that is fast and tai-
lored to your specific needs!
Our Online Support on the Internet:
www.siemens.com/gigasetcustomercare
This site can be accessed at any time wher-
ever you are. It will give you 24/7 support
for all our products. It also provides inter-
active troubleshooting, a list of FAQs and
answers plus user guides for you to down-
load. You will also find frequently asked
questions and answers in the Questions
and Answers section of this user guide in
the appendix.
If you need to examine the phone, require
assistance operating it or wish to make
claims under the warranty, please call
NewPan on 1 700700 727.
If you did not purchase the phone from an
authorized dealer, we will not entertain
any claims made under the warranty.
Authorisation
This product is designed for world-wide
operation, depending on national
approval outside the European Economic
Area (except Switzerland). Country-spe-
cific conditions have been taken into
account. The CE mark attests to the
phone's compliance with the essential
requirements of the R&TTE directive.
The display is blank.
1. The handset is not switched on.
¥
Press the 'end call' key
a
and hold.
2. The battery is flat.
¥
Charge the battery or replace it (page 5).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press the hash key
#
and hold (page 6).
"Base x“ flashes in the display.
1. The handset is outside the range of the
base.
¥
Move the handset closer to the base.
2. The handset has been de-registered.
¥
Register the handset (page 5).
3. The base is not switched on.
¥
Check the base's mains adapter (page 4).
Handset does not ring.
The ringer is switched off.
¥
Activate the ringer (page 14).
The other party cannot hear you.
You have pressed the
u
( §INT§ ) key. The hand-
set is "muted".
¥
Switch on the microphone again (page 9).
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operating
instructions if necessary.