Snapper ZMT2500KH-1 - Manual (Page 12)

12
Section 3 - OPERATING INSTRUCTIONS
2.2.5. PARKING BRAKE
1. Engage parking brake by pulling the parking
brake lever back to the engaged position.
NOTE: Motion control levers must be in the
Neutral position to engage brake. See Figure 2.6.
NOTE: Engaging the parking brake locks the
motion control levers in the neutral position.
2. Release parking brake by pushing parking
brake lever forward to the released position. See
Figure 2.7.
FIGURE 2.6
FIGURE 2.7
WARNING
DO NOT park the machine on slopes. DO NOT leave
machine with engine running. Stop engine. Stop
blades. Engage parking brake. Remove key.
MOTION CONTROL LEVERS IN NEUTRAL
POSITION
PARKING BRAKE LEVER
IN ENGAGED “ON”
POSITION
PARKING BRAKE LEVER IN
RELEASED “OFF” POSITION