Sharp AL-1551 User Manual
Page 21
19
3
Making copies
NORMAL COPYING
A. When using the RSPF:
(1) Make sure that no original is left on the original table.
(2) Adjust the original guides to the size of originals.
(3) Set the originals face up in the document feeder tray.
●
Before feeding originals in the document feeder tray, be sure to remove any
staples or paper clips from them.
●
Before placing curled or wavy originals into the document feeder tray, be
sure to flatten them. If not, original misfeeds may result.
●
The RSPF (
) indicator on the operation panel will light up. If this indicator
does not light up, the originals are not properly set or the RSPF is not properly
closed.
●
Badly damaged originals may misfeed in the RSPF. It is recommended that
such originals be copied from the original table.
●
Special originals such as transparency film should not be fed through the
RSPF, but should be placed directly on the original table.
●
Image loss (max. 5/32" (4 mm)) can occur at the leading and trailing edges of
the copies. Also image loss (max. 11/64" (4.5 mm) in total) can occur along
the other edges of the copies. It can be 15/64" (6 mm) (max.) at the trailing
edge of the second copy of two-sided copying.
Original face up
B. When using the original table:
(1) Open the original cover.
(2) Place an original face down on the original table. Align it with the original scale
and the centering ( ) mark. Close the original cover.
mark
Original scale