Smeg A1XCU6 - Manual (Page 3)

Important Safety Instruction
5
WARNING
To reduce the risk of fire, electrical shock, injury to persons, or damage
when installing the range, some basic precautions must be followed,
including:
- Read all instructions
- Proper installation is your responsibility. Have a qualified technician to install and ground this
appliance, in accordance with these installation instructions.
- It is the responsibility of the installer to comply with the installation clearances specified on the
model/serial I.D. plate. The I.D. plate is visibly positioned in the oven door frame and must not be
removed.
CAUTION: To eliminate the risk of burns or fire caused by reaching over heated surface units, cabinet
storage located above the surface unit should be avoided.
- ELECTRICAL GROUNDING REQUIRED: See the “Electrical Connection” section. It is under the
customer’s responsibility:
1 To contact a qualified electrician to install the appliance
2 To ensure that the electrical system is adequate and in conformance with the national ANSI/NFPA
70 ELECTRICAL CODE – LATEST EDITION, or the CSA STANDARD C22.1, CANADIAN
ELECTRICAL CODE, PART 1 – LATEST EDITION and all local codes and ordinances for the
kilowatt rating of the range.
- Before you plug an electrical cord, be sure that all the controls are in the OFF position.
- Never modify or alter the construction of the appliance. For example, do not remove leveling legs,
panels, wire or anti-tip brackets/screws.
CAUTION: This unit is design as a cooking appliance. Based on safety considerations, never use it for
warming or heating a room.
- Do not obstruct ventilation openings and heat dispersal slits.
- Immediately after installation carry out an inspection test of the appliance, following the instructions
on this booklet. If the appliance doesn’t work properly, disconnect it from the electrical and gas
supply and call the technical assistance centre. Do NOT attempt to repair the appliance.
- Any adjustment and servicing must be performed only by qualified cooker installers or service
technicians.
- Do not leave the packaging in the home environment. Separate the various waste materials and take
them to the nearest special wastage collection centre.
SAVE AND KEEP THIS BOOKLET