Smeg SM1634 - Manual (Page 16)

▼ PROGRAMMER KNOB “STOP”:
The stop function resets the washing machine. If, for any reason, you
want to change the wash program or add more washing to the load
during the wash cycle, simply place the programmer knob in position
“STOP” (the button will start to flash). Then re-position the knob on the
new program and press the “START” button.
SM1639
GB
MAIN FUNCTIONS
OPTIONAL FUNCTIONS
▼ PRE-WASH:
Press this button and the machine will perform a prewash at the maximum
temperature of 40
°
C.
This function can only be used on the “COTTON” and “SYNTHETICS”
programs.
▼ START BUTTON:
After selecting the required program, press this button to start the wash
cycle. Button (A) will light up to indicate the wash cycle has started.
On completion of the wash cycle, the lit button (A) will switch off. The
door can then be opened and the clean washing removed from the drum.
NB. The use of this function depends on the type of program selected.
Consequently, if the wash program does not include this function,
the button cannot be enabled (see “PROGRAM TABLE”).
L
STOP
O
▼ ENERGETIC WASH:
When this button is pressed, the washing machine will run a wash cycle
at the set temperature, though with a longer duration. The button is
enabled for the “COTTON” and “SYNTHETICS” programs.
N.B. When this option is used, the detergent must also be added to
the appropriate prewash compartment.
▼ NO SPIN:
When this button is pressed, the washing machine will effect a wash
cycle without spinning. The button will light up.
Lavaggio
energico
Prelavaggio Esclusione
centrifuga
Lavaggio
energico
Prelavaggio Esclusione
centrifuga
Lavaggio
energico
Prelavaggio Esclusione
centrifuga
Warning!! only use this function if strictly necessary and then only if the program to reset has
not been running for more than 3 minutes. Before opening the door after a reset, wait 2 minutes
for the locking mechanism to release.
Avvio