Smeg SC321N - Manual (Page 20)

42
Instructions for the installer
13.2 Positioning the oven
The oven is designed for mounting into any piece of furniture as long as it
is heat-resistant. Proceed according to the dimensions shown in Figures
1, 2 and 3. For installing under a work top, follow the dimensions given in
Figure 1-3. When installing under worktops incorporating combined hobs,
a gap of at least 110 mm must be left from any side wall, as shown in
figure 1.
When installing in tall units, comply with the dimensions shown in figure 1-
2, bearing in mind that the top/rear of the unit must have an opening 80-90
mm deep. Tighten the 4 screws A inside the frame (fig. 1). For installing
beneath a non-integrated top, allow for a rear and bottom clearance as
shown in Figure 1 (ref. B). See relevant instructions for fitting and securing
the hob.
Never use the oven door to lever the oven into
place when fitting. Avoid exerting too much
pressure on the oven door when open.