Shoprider PHFW-1018 User Manual
Page 12
7/18/2011
12
Folding the Wheelchair
To fold the wheelchair, it is necessary to remove certain
components. Follow these simple guidelines:
1. Park the chair on a level surface.
2. Ensure the wheels are in drive mode.
3. Fold up footplates and/or remove the entire leg rest assemblies
(see Figures 8, 10 and 11).
4. Disconnect the black and red connectors situated under the
seat (Figure 7).
5. Carefully lift up the first rear battery box out of the supportive
bracket by using the lifting strap (battery is heavy).
6. Slide second battery box outward and follow the same steps as
this guidelines No. 5 to lift up the second battery box.
7. Remove seat cushion, carefully place hands under the seat
bottom and give a sharp pull upward. This will pull the entire
frame together (Figure 8).
Quick Release and Install the Anti-tip Wheels
Depress the trigger to make the lock pin sink
simultaneously to pull out the anti-tip wheel.
Do the same steps to remove the other
Anti-tip wheel. To install the Anti-tip wheel,
just insert into the tube of the frame until the
lock pin’s jumping up to lock the hole securely.
Connectors
Lifting Straps
Pull Seat Bottom
Upward
Figure 7
Figure 8
Trigger
Lock Pin
Anti-tip
wheel