Sun Microsystems Sun StorageTek SG-XPCIE20FC-NEM-Z - Manual (Page 29)

Chapter 2 Hardware Installation and Removal 13
FIGURE 2-3 Connecting the Optical Cables
2. Connect the other end of each cable to a FC device.
After the optical cables are connected to the NEM, proceed to “Configuring the NEM
For Hot-Plug Operation” on page 14 .
3. Observe the light-emitting diodes (LEDs) status for the power-on self test
(POST).
Each port has a corresponding set of LEDs that provide a visual indication of the
operating state. See
FIGURE 2-4 to determine the location of the port LEDs.