Sun Microsystems Sun StorageTek SG-XPCIE20FC-NEM-Z - Manual (Page 34)

18 Sun StorageTek 4 Gb FC NEM 20-Port Host Bus Adapter User’s Guide • February 2008
4. Verify that the selected NEM has returned the expected feedback.
See “To Verify NEM Status” on page 17 .
Using the ILOM CLI
1. Log in to the ILOM CLI of the active Chassis Monitoring Module.
2. For a list of components in your system, type:
show /CH
3. To verify that the NEM Ready to Remove status has changed to Not Ready,
type:
show /CH/ component prepare_to_remove_status
The system returns:
prepare_to_remove_status = Not Ready
4. Verify that the selected NEM has returned the expected feedback.
See “To Verify NEM Status” on page 17 .
▼ To Verify NEM Status
See TABLE 2-3 for a description of the LED states for the NEM. See FIGURE 2-5 for the
location of the LEDs, Attention button, and Locator button.
1. Check the following LEDs to verify that the NEM is ready for a hot-plug
insertion.
■ Green OK LED goes to Standby.
2. Activate the NEM by pressing the Attention button, and the green OK LED
goes to Slow blink.
■ When all links to active blades have been made, the green OK LED goes to Solid
On.