Sanyo HT27547 - Manual (Page 14)

5 Press the POWER key. (Follow on-screen instructions).
14
6 Perform “All Channel Search.” The All
Channel Search will search for off-air digital
and analog channels, and analog cable
channels. The DTV can receive cable or off-
air channels, but not at the same time. If
after two searches the DTV still fails to
detect any channels, the DTV will tune to
Video1.
4
Plug AC Power Cord (supplied) into an
electrical outlet as shown here.
To 120 V AC outlet.
GETTING STARTED (REQUIRED INITIAL SETUP) Continued
➠
Channel Search [Analog & Digital]
on-screen display
3 Connect Signal to the DTV’s an Analog 75 ohm Antenna Input terminal.
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels
using the “Digital Cable Search” menu
option.
OR
3. The output from a VCR or cable box.
Digital signals from a Set-Top (STB) Box should be
received through the Component jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
Analog RF Antenna Connection
Connect a Cable signal (with or without a cable
box) or RF antenna to the Analog RF input.
ANALOG CABLE
RF
ANTENNA
DTV BACK
OR OR
POWER
CABLE BOX OR
SATELLITE BOX