Skil 3380-01 - Manual (Page 14)

14.
Maintenance
To reduce the risk of injury, turn
power switch “OFF” and remove
plug from the power source outlet before
maintaining or lubricating your grinder.
GENERAL
Frequently blow out any dust that may
accumulate inside the motor.
An occasional coat of paste wax on the work table
will allow the wood being cut to glide smoothly
across the work surface.
Certain cleaning agents and
solvents damage plastic parts.
Including: gasoline, carbon tetrachloride,
chlorinated cleaning solvents, ammonia and
household detergents that contain ammonia.
Avoiding use of these and other types of cleaning
agents minimizes the probability of damage.
To avoid shock or fire hazard, if the
power cord is worn, cut or damaged
in any way, have it replaced immediately.
All repairs, electrical or mechanical,
should be attempted only by trained
repairmen. Contact the nearest Skil Factory Service
Center, Authorized Skil Service Station or other com-
petent repair service. Use only Skil replacement
parts; any other may create a hazard.
Lubrication
All of the BALL BEARINGS are packed with grease at
the factory. They require no further lubrication.
Accessories
Use only recommended accessories. Follow
instructions that accompany accessories. Use of
improper accessories may cause hazards.
Maintaining Your Bench Grinder
WARNING !
CAUTION
!
WARNING
!
WARNING
!