Skil 3380-01 - Manual (Page 9)

9.
Assembly and adjustments
To reduce the risk of injury, never
connect plug to power source outlet
until all assembly steps are completed.
Fitting and adjusting the spark
deflectors and eye shields
IMPORTANT: Prior to fitting the eye shields and spark
deflectors, ensure the grinder is turned off and the
power plug is removed from the socket.
Note: Always check to ensure the eye shields are
correctly fitted and the eye shield spark deflectors are
correctly adjusted each time the grinder is used. Eye
shields and spark deflectors must be fitted over each
grinding wheel.
1.Remove the bolt (1,2,3,4) from the top of the wheel
guard shown in figure 2.
2.Position the spark deflector (5) to the top of the
wheel guard as shown in figure 2.
3.Reinsert the bolt (1) through the spark deflector and
wheel guard, followed by the washer (2), lock
washer (3), and nut (4).
4.Tighten to secure the spark deflector onto the wheel
guard.
5.Hold the eye shield (6) upside down and insert the
light assembly (7), by siding it into position between
the shield and the shield’s support bracket (8), as
shown in figure 3.
6.Position the eye shield on the spark deflector
bracket as shown in figure 4.
7.Place a lock washer (9) and a flat washer (10) to
each eye shield locking knobs (11), then insert
through the spark deflector bracket and thread into
the eye shield, tighten the knob in a clockwise
direction to secure the eye shield onto the spark
deflector bracket.
8.Rotate the wheel by hand one full revolution to
ensure the wheel can rotate without contacting the
spark deflector bracket. Firmly tighten the knob
retaining the bracket.
9.Repeat for the opposite side.
WARNING
!
FIG. 2
FIG. 3
FIG. 4
5
4
3
2
1
7
6
8
9 11
11 9 10
10