Kawai CN21 - Manual (Page 33)

Page
33
APPENDICES
6
3. Place the piano on the front half of the stand so that the
metal fi tting holes are seen when viewed from the top. Slide
the piano backward while holding it with one hand so that it
does not incline and fall from the stand. The hooks on the
piano are then engaged with the metal fi ttings on the Side
Panels. Pay attention so that hands or fi ngers are not caught
between the stand and piano. Fasten the piano and the stand
with four bolts (with plain washers and spring washers)(F').
First, loosely tighten the bolts to adjust the unit position in
order to make sure that all four bolts can be inserted straight.
Then, tighten the bolts.
Make sure that the bolts are tightened until the spring
washers collapse.
4. Insert the pedal connection cord that comes from Pedal
Board (C) into the piano's pedal jack and fasten with cord
clamps.
5. Fix the headphone hook to the location marked with red ink by
using two tapping screws provided in the same plastic bag.
6. Turn the Adjuster (installed on the bottom of C) until it touches
the fl oor to support the pedal board.
Caution
y Ensure that the CN21 piano is correctly secured to the stand by using the bolts included.
Failing to do so may result in the unit falling from the stand, causing damage or personal
injury.
Hand or Finger
catching hazard
Caution y The pedal board may break if the adjuster
is not touching the floor correctly. When
moving the CN21 piano, ensure that the the
unit is lifted clearly from the floor and not
dragged.
(F')
backside of the unit
Pedal jack
Cord
clamp
Pedal
cord
connector
Locking
tab
Red mark
Adjuster
Pedal board
Floor