Kingston Technology PCREAD/SSFDC - Manual (Page 9)

Hardware Installation 3
SSFDC ™ Card Reader - Rev. A00 Kingston Technology Company
Installing the SSFDC
™
Reader
The SSFDC ™ Card Reader is designed to connect to your desktop PC’s IBM
compatible parallel port. The instructions beginning below describe how to
attach the SSFDC
™ Card Reader to your PC.
Step 1. Parallel Port Connection
1. Place the computer’s power switch in the OFF position.
2. If present, place the printer’s power switch in the OFF position.
3. If present, remove the cable extending between your computer’s
parallel port connector and your printer.
4. Plug the SSFDC ™ Card Reader’s 25-pin connector into your
computer’s parallel port connector. To make sure the SSFDC ™ Card
Reader does not pull loose, tighten the thumb screws as indicated
below.
SSFDC ™ Reader to Parallel Port Connection
PARALLEL
POR
T
Use the thumbscrews on
each side of the connector
to secure the device to your
parallel port.