Kyocera K132 - Manual (Page 9)

User Guide for the Kyocera K132 Phone 1
1 G
ETTING
S
TARTED
Installing the battery
Your Kyocera K132 phone comes with a
removable lithium ion (LiIon) battery.
Fully charge the battery before using the phone.
To install the battery:
1. Hold the phone face
down.
2. Toward the bottom of
the phone there is a
recess to aid you in
opening the battery
door. Use your
fingernail to pull the
battery door away.
3. Place the battery in the
phone casing with the
metal contacts toward
the bottom of the phone.
4. Place the battery door
tab in the openings near
the top of the phone.
5. Press the battery door
until it clicks into place.
Note: Before you remove the battery, make sure
the phone is powered off.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter
to the jack on the
bottom of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Note: The battery will not charge if you use the
phone while it is connected to an AC adapter.
Note: If you are using a 400 mA charger with any
of the following part numbers: CV90-G2968-01;
CV90-G2610-02; or CV90-60859-1, please be
aware that this power unit is intended to be
correctly oriented in a vertical or floor
mount position.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
GettingStarted.fm Page 1 Tuesday, October 3, 2006 9:58 AM