Konftel 100 R - Manual (Page 11)

or
and and
and
and
MUTE, T
APE RECORDER AND PROGRAMMING
and
Mute function
Switches off the microphone, and the red LEDs
are extinguished. Press again to switch on the
microphone.
Tape recorder outlet
An outlet for a tape recorder is provided on the
bottom of KonfTel 100 R. The outlet is designed
for a Tele 3.5 mm tape recorder connector.
Store speed dial numbers
– KonfTel 100 R switched off
Press PRG to open the memory.
Enter the desired telephone number including
PAUSE,
* or # , if any. Press PRG. Select the
storage location, from 0-9. Note that an old
number already stored in the same location will be
replaced without prior warning.
– KonfTel 100 R switched on
Dial the desired number. Press PRG. Select the
storage location, from 0-9. Note that an old
number already stored in the same location will
be replaced without prior warning.
Pause is used to enter a pause when dialling - this
may be necessary for certain exchanges and
country codes.
Retrieve speed dial number
Switch on KonfTel 100 R and wait for the dialling
tone. Retrieve a speed dial number with PRG
followed by its position. Press R to retrieve several
numbers.
Three-party calls
Call the first participant. Press R and wait for a
new dialling tone. Call the second participant.
End with R followed by 3. Three lines are now
connected in a conference call. Note that three-
party calls cannot be connected via certain
company exchanges.
9