Karcher KMR 1250 D - Manual (Page 11)

KMR 1250 D
User Instructions
English
35
Braking
n
Release the drive pedal and the sweeper will brake auto-
matically.
Important note: Safety!
It is possible that the automatic braking function will not be
sufficient to bring the sweeper to a halt. In this case, either
make use of the parking brake as well or gently press the
drive pedal in the opposite direction to travel.
Stopping the sweeper and switching off
n
Release the drive pedal. The sweeper brakes automati-
cally and comes to a halt.
n
Apply the parking brake .
n
Set the throttle lever to minimum engine speed (to the
rear).
n
Make sure the main roller and side brush are
raised so that the bristles are not damaged.
n
Switching off
– Turn the ignition key counter-clockwise to the 0 positi-
on and then remove it.
After the engine has been switched off, the filter is
automatically cleaned for approx. 10 seconds.
Cleaning the filter Automatic cleaning
n
Stop the sweeper and switch off the engine.
After the engine has been switched off, the filter is auto-
matically cleaned for approx. 10 seconds.
Manual cleaning
While the sweeper is operating, the filter should be cleaned
approx. every 15–30 minutes (depending on amount of
dust).
n
Stop the sweeper.
n
Set the sweeping mode lever to wet .
n
Give a short press on the filter cleaner button , the
filter is cleaned for about 10 seconds. .
n
Set the sweeping mode lever back to dry .
n
Continue with cleaning task as before.