Kenmore 587.144 - Manual (Page 11)

11
Car Car Car Car Care and Cleaning e and Cleaning e and Cleaning e and Cleaning e and Cleaning
Outside Outside Outside Outside Outside —Occasionally wash with a mild
nonabrasive detergent and water. Rinse and dry.
Inside Inside Inside Inside Inside —The inside of the dishwasher is self-
cleaning with normal use.
To clean Stainless Steel wipe with the grains.
Use a Dishwasher Safe Detergent to help with the
stains or discolorations.
Never use products that contain Chlorine Bleach
or Citric Acid
Important: The dishwasher motor is
permanently lubricated at the factory and does
not need to be oiled.
Burn Hazard
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Car Car Car Car Care of Drain Air Gap e of Drain Air Gap e of Drain Air Gap e of Drain Air Gap e of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. Drain air gaps are
usually mounted on countertop and can be
inspected by removing the cover. A drain air gap
is not part of your dishwasher and is not covered
by this warranty.
ENGLISHENGLISHENGLISHENGLISHENGLISH
Winterizing Winterizing Winterizing Winterizing Winterizing
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person
do the following:
T T T T To Disconnect Ser o Disconnect Ser o Disconnect Ser o Disconnect Ser o Disconnect Service: vice: vice: vice: vice:
1. Turn off electrical power to the dishwasher at
the supply source by removing fuses or tripping
circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect
water line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain
water into pan.
Note: See Installation Instructions for more details.
T T T T To Restor o Restor o Restor o Restor o Restore Ser e Ser e Ser e Ser e Service: vice: vice: vice: vice:
1. Reconnect the water, drain, and electrical
power supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher
through a NORMAL WASH Cycle.
4. Check connections to make sure they do not
leak.
Note: See Installation Instructions for more details.