Englishenglishenglishenglishenglish – Kenmore 587.144 User Manual

Page 12

Advertising
background image

12

Car

Car

Car

Car

Care and Cleaning

e and Cleaning

e and Cleaning

e and Cleaning

e and Cleaning

continued

Property Damage Hazard

Freezing temperatures may cause water

lines to rupture. Be sure all supply lines to

and circulating lines within dishwasher are

protected.
Failure to do so could result in property

damage.

ENGLISHENGLISHENGLISHENGLISHENGLISH

For optimum performance, your dishwasher is

equipped with a filter assembly featuring a main

filter, cup and fine filter as shown in the drawing

above. All food fragments are removed from the

dishwasher as water passes through the filter

assembly.

Each part of the assembly should be cleaned often

to ensure that all food fragments are removed from

the dishes. To remove food fragments from the

filter assembly, the filters must be removed from

the dishwasher. To remove the filters, pull up on

the edge of the main filter. Next, rinse the main

filter and fine filter under running water. Cleaning

with a brush may also be necessary to remove

any fragments trapped in the filters. Once

cleaning has been completed, simply reassemble

the filter as shown in the drawing above. To

ensure that the filter is fully seated, please press

down on the top of the main filter. Using the

dishwasher without a properly installed filter is

not recommended as it will reduce the

cleaning efficiency and may damage dishware.

Cleaning the Spray Arm

Cleaning the Spray Arm

Cleaning the Spray Arm

Cleaning the Spray Arm

Cleaning the Spray Arm

The spray arm may need to be cleaned to insure
that there are no clogs to the spray arm jets and
bearings due to hard water chemicals.

To remove spray arm simply hold the spray arm in
place and turn the retaining nut clockwise

and

pull up on the spray arm lifting off the shaft.

To clean the spray arm use warm soapy water
using a soft brush to clean the jets and bearings.

To replace the spray arm simply set the spray arm
on the shaft, take the retaining nut and turn it
counter clockwise till it has locked into place.

Cleaning the Filter

Cleaning the Filter

Cleaning the Filter

Cleaning the Filter

Cleaning the Filter

Advertising
This manual is related to the following products: