Kodak XLS 8400 - Manual (Page 27)

Network Printer Parameters
4-2 Part No. 1H9613 June 1997
NOTE: If you are setting up a Kodak Digital Science
TM
Desktop
Color Proofer 9000, refer to the user’s guide for the
Network Interface Card shipped with the proofer for
specific instructions on using the operator control panel.
1. Press Setup/Select on the display panel when “READY”
appears in the panel.
2. Press until SETUP: DEFAULTS appears.
3. Press Setup/Select to select “SETUP: DEFAULTS.”
4. Press Setup/Select to select “DEFAULTS: FACTORY.”
5. Press Setup/Select to select “FACTORY: RESET.”
Wait for reset/initialization to finish before you attempt other
operations.
Printer Parameters - General
Ethernet Address
Default: Factory Programmed in the form of 00:40:C8:xx:xx:xx
The Ethernet hardware address is programmed into the Network
Interface Card at the factory and cannot be modified by users.
This address is necessary for properly naming the kxxxxxx setup
file.
Power
Error
Cancel Print
Setup/Select scroll
” “