Complete the installation, Installation checkout – Kohler Digital Interface K-684 User Manual

Page 9

Advertising
background image

4. Complete the Installation

IMPORTANT!

Make drip loops in all cables and cords.

Press the clips to release and open the access door on the valve.

Slide the hinge side of the door in either direction until one side slips free.

Remove the door.

Connect the interface cable(s) to the valve.

Connect the power supply to the valve.

Verify all molded grommets are in place before closing the access cover.

Reinstall the access door.

To close the access door, press on the tabs until the clips snap into place.

Plug the power supply into the outlet.

5. Installation Checkout

Turn on the water supply to the valve.

Check all connections for leaks and make any adjustments as needed.

Turn on the main power supply. You should hear the valve power up and the power icon on the
user interface will be lit with a green pulsing light.

If not already completed, refer to the

″Digital Interface Homeowners Guide″ to set up the interface.

Screws

Molded Grommets

Internal Interface Cable

Optional External
Interface Cable

Drip Loop

Drip Loop

Clip

Tab

Door

Drip Loop

Power Supply

Power Supply

Kohler Co.

9

1043184-2-B

Advertising
This manual is related to the following products: