Dtmf n, Dtmf t – Kenwood TM-271A User Manual
Page 59
52
10
6 Repeat steps 4 and 5 to enter up to 16 digits.
7 Press [MENU] to complete the entry.
• Press any key other than [MR], [VFO], [F], and [MENU]
to cancel the entry.
• To complete an entry of less than 16 digits, press
[MENU] two times.
8 Press any key other than [MENU] to exit Menu Mode.
C
ONFIRMING
S
TORED
DTMF N
UMBERS
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 28 (DTMF.MR).
2 Press [MENU] and turn the Tuning control to select
your desired DTMF Memory Channel number from 0
to 9.
• You can also select a DTMF Memory Channel by using
Mic [UP]/[DWN].
3 Press [REV].
• The numbers scroll across the display and the DTMF
tones emit from the speaker without transmitting.
4 Press any key other than [REV] or [MENU] to exit.
T
RANSMITTING
A
S
TORED
DTMF N
UMBER
1 Press Mic [PTT] + Mic [PF/D].
2 Release Mic [PF/D] (continue pressing Mic [PTT]),
then press a key from 0 to 9 to transmit the desired
DTMF Memory Channel number.
• To transmit tone “D”, press Mic [PF/D] again.
• The number stored in the channel scrolls across the
display, accompanied by DTMF tones from the speaker.
(DTMF tones are not emitted if Menu No. 33 (DT.M) is
set to “OFF”.)
• After transmission, the frequency display is restored.
3 Release Mic [PTT].
Note:
◆ If you select an empty DTMF Memory Channel and press
[MENU], the frequency display is restored.
◆ In step 2, above, you can preview the DTMF Memory Channels
first by turning the Tuning control or pressing Mic [UP]/[DWN].
A
DJUSTING
THE
DTMF T
ONE
T
RANSMISSION
S
PEED
This transceiver allows you to configure the DTMF
number transmission speed between Fast (default) and
Slow. If a repeater cannot respond to the fast speed,
adjust this parameter.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 29 (SPD).
2 Press [MENU] and turn the Tuning control to select
“FA” (Fast) or “SL” (Slow).
• The tone duration of Fast is 50 ms and Slow is 100 ms.
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.