Kawai LH-1 - Manual (Page 28)

28
MIDI Channel
The number below the word Channel in the Display is the current operating MIDI
Channel. Note also the MIDI Channel box in the lower left corner of the Display. Press
either the DOWN or UP ARROW function button to change the MIDI Channel from one
(1) to sixteen (16) or MIDI OFF.
NOTE: The LH-1 Transmits or Receives played key data only. Transmit and
Receive Channels cannot be assigned individually. The default is Channel 1.
MIDI Channel 1 to 16: Press the DOWN or UP ARROW to change the MIDI Channel. A
MIDI channel is chosen to send or receive MIDI data when the LH-1 is used with other
MIDI-equipped instruments or modules. Some instruments or modules may not have the
selectable channel feature or may have a limited range of channels.
MIDI OFF: Choosing MIDI Off disconnects the LH-1’s MIDI System. When MIDI is
OFF, the LH-1 will not transmit or receive MIDI information.
LOCAL On/Off: With Local On, the LH-1 transmits “played note” data into the MIDI
system. With Local Off, the LH-1 will not transmit the “played note” data to its own sound
generator. Therefore, the notes played may be heard on other instruments attached to the
LH-1 via MIDI, but not through the LH-1 itself.
Tuning
Tuning of 440.0 Hz (A=440) is the LH-1’s default factory setting. However, Tuning may
be changed from a low pitch of 427.0 Hz to a high pitch of 453.0 Hz. This allows the LH-1
to be played with different musical instruments or ensembles that may have tuned to a
different pitch. Press the DOWN or UP function button repeatedly to change the pitch.
You can hear the pitch changes by selecting the ORGAN 2 sound and holding a key down
while repeatedly pressing the Tuning DOWN or UP button. Tuning is active for the seven
sounds and the Hymns and Children’s Songs feature.
3. Restore Factory Settings
This function will Reset all SYSTEM MODE settings to the factory default settings,
providing a quick return to all original settings that existed when the LH-1 arrived.
To restore Factory Settings, enter SYSTEM MODE and press the Restore Factory
Settings button. The LCD Display should change.