King Kutter Free Floating Finishing Mower User Manual
Page 19
OPERATING INSTRUCTIONS
This mower was designed to CUT LAWN GRASS ONLY. Use of your finishing
mower to cut any material other than lawn grass may damage the mower and
void your warranty.
CUTTING HEIGHT ADJUSTMENT
To prevent blades from striking the ground your finishing mower should be set to
the highest position that will give desired grass height. By setting your mower up
this way you reduce blade wear and stress on the mower. Mowing at regular
intervals will yield far better results than periodic mowing. (i.e. weekly vs. by-
weekly mowing.)
STEP 1
Raise finishing mower off the ground with the tractor and SECURELY BLOCK IN
POSITION.
STEP 2
Remove pin from top of wheel fork assembly. Lower wheel fork assembly from
tail wheel arm.
STEP 3
Arrange spacers until desired cutting height is achieved. Cutting heights range
from approximately 2.0-6.0 inches in height.
STEP4
Reinstall wheel fork assembly into tail wheel arm and install keeper pin.
STEP 5
Repeat adjustment process on remaining wheel fork assemblies. NOTE: Make
sure all are adjusted to the same height for an even cut.
19