Cd player unit, Cassette deck unit, Remote control unit – Kenwood FM/AM Reciever R-SE7 User Manual

Page 54

Advertising
background image

R-SE7/DP-SE7/X-SE7 (En)

54

Preparation section

Basic section

Application section

Knowledge section

In case of difficulty

Remedy

Cause

Symptom

CD player unit

÷ Place the disc properly, with the

label side facing upward.

÷ Place the disc properly.

÷ Clean the disc referring to “Disc

handling precautions”.

÷ Try another disc.

÷ Refer to “Beware of condensation”

and remove the condensation by
evaporation.

÷ Place a disc in the CD player.

÷ Press the 6 key.

÷ Clean the disc referring to “Disc

handling precautions”.

÷ Try another disc.

÷ Clean the disc referring to “Disc

handling precautions”.

÷ Try another disc.

÷ Install the unit in a place not sub-

ject to vibrations.

A CD is placed in the player but it
cannot be played.

Sound is not produced.

Sound skips.

÷ The disc is placed upside down.

÷ The disc position is displaced.

÷ The disc is extremely dirty.

÷ The disc is scratched.

÷ Dew is condensed on the optics lens.

÷ The disc has not been placed.

÷ The player is not put to the play mode.

÷ The disc is extremely dirty.

÷ The disc is scratched.

÷ The disc is dirty.

÷ The disc is scratched.

÷ The player is subject to vibration.

)

)
o

Q

)
)
o

o

1.With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape

protection function, and not a malfunction.

2.Do not use longer than 110 minutes tapes, for the tape is too thin and gets easily tangled.

Notes

Notes

Remedy

Cause

Symptom

Cassette deck unit

÷ Use a cassette with an unbroken re-

cording protect tab or block the hole.

÷ Select the source to be recorded

with the input selector key.

÷ Change the tape transport direc-

tion or reverse the tape insertion
orientation.

Recording cannot be started by
pressing the record key.

p

ª

÷ The recording protect tab of the

cassette has been broken.

÷ The TAPE input is selected.

÷ The tape is fully wound to one of

the reels.

Remote control unit

Symptom

Cause

Remedy

Remote control operation is not
possible.

÷ Batteries are exhausted.

÷ The remote control is too far away

from the system, the controlling angle
is deviated or there is an obstacle in
between.

÷ There is no tape or CD set in the

component to be played.

÷ An attempt is made to play the cas-

sette deck which is recording some-
thing.

÷ Replace with new batteries.

÷ Operate the unit inside the remote

controllable range.

÷ Set a tape or CD in the component

to be played.

÷ Wait until the recording ends.

&
&

Advertising
This manual is related to the following products: