Regulatory compliance, Fcc compliance and advisory, Fcc and industry canada – Kodak ESP 5 User Manual
Page 76
Product and Safety Specifications
70
Kodak ESP 5 Printer User Guide
Regulatory Compliance
FCC Compliance and Advisory
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed or used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following measures: 1) reorient or relocate
the receiving antenna; 2) increase the separation between the equipment and the receiver;
3) connect the equipment to a different outlet (on a circuit) than the one the receiver is
connected to; 4) consult the dealer or an experienced radio/TV technician for additional
suggestions.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. To ensure
compliance with FCC regulations, use only the shielded interface cables provided with the
product, or additional specified components or accessories that can be used with the
installation of the product.
FCC and Industry Canada
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to
the following two conditions:
1
This device may not cause interference and
2
This device must accept any interference, including interference that may cause
undesired operation of the device
Caution:
When using the Bluetooth interface with a Kodak printer,
the transmitter must not be collocated or operated in conjunction
with any other antenna or transmitter.