Kawasaki NINJA 73690 - Manual (Page 10)

• Position the vehicle body upright. Face the back end of the
vehicle body.
Hint: You will need to temporarily hold the remaining rear
wheel driver onto the motor assembly to properly position
the rear axle assembly into the motor assembly.
• Fit and hold the remaining rear wheel driver against the
motor pins on one end of the motor assembly, as shown.
• While holding the rear wheel driver in place, slide the rear
axle assembly into the hole in the opposite side of the
motor assembly. Make sure the rear wheel driver on the
rear axle assembly fits onto the pins in the motor
assembly.
• Slide the rear wheel driver off the end of the
rear axle.
Rear Axle Assembly
Washer
Rear Wheel
Driver
Cap Nut
Cap Nut
Assembly Tool
Hubcap
Rear Axle
Motor Assembly Pins
• Slide a washer onto the rear axle.
• Slide the rear wheel driver onto the rear axle. Make
sure the rear wheel driver fits onto the pins in the
motor assembly.
• Slide a wheel onto the rear axle. Make sure the ribs on
the wheel fit into the grooves on the rear wheel driver.
• Slide a hubcap, indented side out, onto the rear axle.
• Fit a .437 cap nut on the end of the rear axle.
• Fit the cupped end of the cap nut assembly tool over
the cap nut and tap the end of the cap nut assembly
tool with a hammer to secure the cap nut on the end of
the rear axle.
Rear Wheel Driver
Assembly
• Slide a hubcap, indented side down, onto the rear axle.
• Slide a wheel onto the rear axle. Make sure the ribs on
the wheel face up.
• Slide a rear wheel driver, ring side down, onto the rear
axle. Fit the grooves on the rear wheel driver onto the
ribs on the wheel.
• Slide a washer onto the rear axle.
Rib
Wheel
Rear Wheel Driver
Hubcap
10
4
5
6
Motor Assembly
Motor Assembly
Washer
Rear Axle