Krown Manufacturing KBS300RX - Manual (Page 6)

ALARM MONITOR KA300 WORKS
KA300system is designed to monitor all existing acoustic alarm units in your living
area and transfer it to a visual and vibration alarm. It will quickly help you to
determine what source triggered the alarm and give you enough time to evacuate
from the building or to locate a shelter. The KA300 is not an alarm system but it is
the vital source for the Deaf and Hearing Impaired to rely upon in an emergency. In
most cases, the alarm was caused by Fire, Smoke, Carbon monoxide, hurricane,
tornado, earthquake, etc.
USING KA300 FOR A SINGLE FAMILY HOUSEHOLD
You must choose one operation
code for KA300 system used for
your house. Set all transmitters
KA300TX to that operation code.
All KA300TX used for a smoke
detector will be set to channel one.
The other will be set for channel
two and three. There will be no
limit for the number of transmit-
ters used in the same channel
setting. However, the distance
from the TX to the RX will be
limited to around 100 feet. If you
have a KBS300RX bed shaker,
you need to program the operation
code for it when you program the
KA300RX. You can program the
bed shaker at a different time. It
will be more convenient to program the operation code for both receivers at the
same time.
Note: The toggle switch will be either in the ON or OFF position. We will call ON position 1 and the
OFF position 0. For example, if all 8 switches are in the ON position, we will write
1111 1111 for that setup code.
CHAPTER
1
HOW YOUR....
2