Kenwood CT-405 - Manual (Page 9)

9
1 Deck A
This deck is used exclusively for play-
back.
2 Deck A eject (0) key 0
Press to open the cassette holder of
deck A.
3 Deck B eject (0) key 0
Press to open the cassette holder of
deck B.
4 Deck B
This deck is capable of both playback
and recording.
5 Deck A operation keys 0~!
1 : Rewind key (for fast winding of
tape toward the left reel seen
from you)
¡ : Fast Forward key (for fast wind-
ing of tape toward the right reel
seen from you)
2, 3 : Play keys
7 : Stop key (Stop)
6 POWER switch 0
Press to turn this unit ON and OFF.
7 PHONES jack !
Connect stereo headphones (optional)
here.
8 TIMER switch ™
This switch is used in setting of timer
playback and timer recording.
9 MODE key ^
Press to change the recording
level,balance,or bias settings.
0 REC LEVEL/BAL/BIAS knob ^
Adjust this before recording.
! Deck B operation keys
2, 3 : Play keys
7
: Stop key (Stop)
1 : Rewind key (for fast winding of
tape toward the left reel seen
from you)
¡ : Fast Forward key (for fast wind-
ing of tape toward the right reel
seen from you)
pause ( 8 PAUSE) key !
:Press to let tape transport pause
temporarily.
record ( ¶ REC/ARM) key ^
:Press in stop mode to start re-
cording or press in record mode
to let the recording pause after
leaving a non-recorded blank of
4 seconds.
@ RESET A key !
Press to reset the tape counter of deck
A to “0000”.
# DOLBY NR key 0
Press to switch the Dolby Noise Reduc-
tion mode to B
= C = OFF. This makes
it possible to use the Dolby NR effect in
recording and playback.
$ REV. MODE key 0
Press to change the tape transport di-
rection.
% NORM.DUBB. key (
Dubbing at the normal speed.
^ HIGH DUBB. key (
Dubbing at a high speed.
& MPX FILTER key &
Press to reduce beat noise when record-
ing FM broadcasts.
* CCRS key ¡
Press to start recording after automatic
setting of the optimum CD recording
level and optimum tape recording bias.
( AUTO BIAS key ^
When this key is pressed, the bias level
appropriate for the tape is set automati-
cally for recording.
) RESET B key
Press to reset the tape counter of deck
B to “0000”.
Controls and indicators