Kenwood CK 780 - Manual (Page 32)

32
G A
Fig. 7.2 Fig. 7.1
INSIDE OF OVEN
This must be cleaned every time it is
used.
Remove and refit the side runner frames
as described in the next section.
With the oven warm, wipe the inside
walls with a cloth soaked in very hot
soapy water or another suitable product.
The bottom of the oven, side runner
frames, tray and rack can be removed
and washed in the sink.
FITTING THE OVEN OUT
– Hang up the wire racks “G” on the
oven walls interposing the self clean-
ing panels “A” (fig. 7.1)
– Slide the required shelf and tray etc. in
using the guides (fig. 7.2).
– Reverse the above order to dismantle.
ADVICE FOR USE AND MAINTE-
NANCE OF SELF CLEANING PANELS
The self cleaning panels are covered
with a special microporous enamel
which, absorbs and removes oil and fat
splashes during normal baking over
200°C.
If, after cooking very fatty foods, the
panels remain dirty, operate the oven
empty on max temperature for about 30
minutes.
These panels do not require to be
cleaned, however it is advised to period-
ically remove them from the oven (at
least the side panels) and to wash them
with tepid soapy water and then wipe off
with a soft cloth.
DO NOT CLEAN OR WASH THEM
WITH ABRASIVE PRODUCTS OR
WITH PRODUCTS CONTAINING
ACIDS OR ALKALIS.
The side panels are reversible and when
the microporous enamel degrades, they
can be turned to the other side.