Kohler K-10103 - Manual (Page 7)

5. Connect the Supplies
CAUTION: Risk of restricted waterflow and product damage.
Use extreme care to avoid kinking and twisting the supply
hoses. Hoses must not be taut when installed. If the supply
hoses must be coiled, maintain an inside coil of 3
″ (7.8 cm).
CAUTION: Risk of product damage. Verify the solenoid
connector and sensor cable are not being pinched when
connecting the supplies.
IMPORTANT! To ensure proper performance of the faucet, the
supply lines must be flushed out before proceeding with the
installation.
Turn on the main water supply.
Turn the supply stops to the ″ON″ position.
Flush water through the supply stops and into a bucket to
remove any debris.
Turn the supply stops to the ″OFF″ position.
Connect the supply hoses to the supply tees with supply stops.
IMPORTANT! Ensure the gasket is in place between the flexible
hose and the outlet of the valve body assembly.
Connect the flexible hose from the faucet to the outlet of the valve
body assembly.
Turn the supply stops to the
″ON″ position.
Flexible Hose
Gasket
Valve Body
Assembly
3/8" Supply Tees
with Supply Stops
Kohler Co. 7 1056542-2-B