Kenyon 436 - Manual (Page 9)

9
8. Wipe any alcohol spills and replace the air deflector assembly into the pan and return the electric
element back into place. Note that the electric element serves as a grate when using the alcohol
burner to cook.
Alcohol Burner Operating Instructions
1. Completely open the flame control cap by rotating the control wheel to the left.
2. Ignite the small fiber wick located in the center chimney. A match may be used or a Bar-B-Que grill-
igniting wand is ideal. Do not leave matches in the center chimney; they will inhibit the efficiency of
the burner.
3. Allow for approximately two minutes to five minutes for flames to appear in the burner jets (see theory
of operation) Cooking may be initiated immediately after ignition of the center chimney. This will not
effect the preheating of the main burner and automatic switch over to normal full operation.
ELECTRICAL OPERATION
Controls are located in the rim of the frame: for alcohol burners, the controls are located in the front of
the appliance; for electric elements, the controls are located in the sides as shown below in the figure.
WARNING: NEVER OPERATE ALCOHOL BURNER(S) AND ELECTRIC ELEMENT(S)
SIMULTANEOUSLY. THIS CAN CAUSE FIRE OR SEVERE INJURY
Operation of Electric Elements
Turn the electric control in either direction to HIGH, LOW, or any intermediate position for exact heat
desired. A Pilot Indicator light, one for each element, stays ON until the electric control is turned to the
OFF position. When finished cooking, make sure both pilot lights are out and that the electric controls are
in the OFF position.
Pilot Indicator Light
Electric Element Control Wheel
Alcohol Burner
Control Wheel
Turning alcohol control
wheel to the left will
provide maximum flame
output
Turning alcohol control wheel
to the right will lower flame
output or extinguish (“snuff”)
flame
Turn Electric Control Wheel
in either direction to HIGH,
LOW, or any intermediate
position for electric element
operation.
436 Model Shown