Kalorik USK CCG080626 - Manual (Page 11)


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Fax +32 2 359 95 50
PROGRAMMING THE COFFEE MAKER
Your coffee maker has a 24 hours timing, but the programmed clock
remains in the memory as long as you do not modify it.
• Check the time displayed on the clock.
• Slide the release button of the lid of the water tank and lift it. Fill
the water tank with cold water. The number of cups can be read
on the graduated water tank. Close the lid.
• Pull the filter holder out using its handle, fill the permanent filter
with the desired quantity of ground coffee or use the grinder (see
“USING THE COFFEE GRINDER” section). Then replace the filter
holder in its initial position.
NOTE: If you do not want to use the grinder and decide to fill the
filter with normal ground coffee, press the GRIND OFF button, the
orange pilot light will come on.
NOTE: You cannot switch this “GRIND OFF” function on or off if the
on/off light (Red), or the timer light (Green) are already lighted.
• Press the PROG button twice successively. The time "12:00" and
‘TIMER" will be displayed on the electronic digital clock.
• Set the desired programming time doing the same as described
for the setting of the clock.
• Once the setting is finished, wait about 15 seconds or press PROG
key until “TIMER” disappears. The programming time will
disappear and will be replaced by the time of the clock.
• Make sure the jug is placed correctly on the hotplate.
• Then press the ON/OFF switch twice successively and the green
PROG pilot light will come on. The coffee machine is ready to
start at the set time.
11 USK CCG 19322 - 080626
Assembly page 11/32