Kenwood XD-DV75 - Manual (Page 43)

43
Operations
XD-DV series (EN/K,M,T,X,Y)/2
Playback of tapes
Load a cassette tape
2
4
Select reverse mode
23 23 7
A A
1 Open the door.
2 Insert a tape
3 close the door.
÷ Remove tape slack before loading.
÷ Close the door securely.
Press the area marked PUSH
OPEN to load or eject a tape.
MAIN UNIT
Start playback
1 “ ” : playback stops after having played both side
of tape in a deck.
2 “ ” : Endless playback of both sides of tape.
3 “ ” : playback stops after having played one side of
tape.
Each press switches the modes as follows
1
÷ If the tape transport direction is opposite to the desired direction,
press the play key corresponding to this.
Tape direction indicators of cur-
rently selected deck.
To wind tape at high speed
REMOTE MAIN UNIT
To stop playback
REMOTE MAIN UNIT
Longer tape than 90 minutes cassette tape:
Since longer tape than 90 minutes cassette
tape is very thin, the tape could adhere to the
pinch roller or be easily cut. It is recommended
that these tapes not be used with this unit to
prevent possible damage.
Notes Notes
This unit can only use tape for the normal position
(Type I ).
REVERSE MODE
REMOTE MAIN UNIT
TAPE A
23
TAPE B
23 23
TAPE A
23
TAPE B
or or
23 23 7
/
TAPE A / TAPE B
STOP STOP
1 , ¡
4 , ¢
REVERSE MODE
Reverse mode indicator
TAPE A or TAPE B indicator
M
U LT
I C
O
N
T R
O
L
/P
.C
A
L L
4
¢
1 ¡
TUNING
STOP
7
STOP
It is possible to reset the tape counter by following method.
ччччч Open the cassette holder.