Kompernass KH 2264 - Manual (Page 7)

6
t
4. Operation
This section applies when the device has
been connected as described in chapter 3:
4.1 Switching the device on/off
൵ The device is equipped with a
FUNCTION sliding switch for all three
modes:
The device is switched on and is consu-
ming electricity when the switch is switched
to …
• "Radio" for radio mode
• "CD" for CD mode.
The device is switched off when the switch
is switched to …
position ...
• "TAPE/POWER OFF". This also the
position for tape mode. In this position,
the device consumes near to no electrici-
ty, as long as none of the tape operating
keys are pressed.
4.2 Adjusting the volume
൴ Turn the volume control clockwise (lou-
der) - or anti clockwise (quieter).
4.3 Bass-booster function
൸ Use the BASS BOOST switch to activa-
te or deactivate the Bass booster func-
tion.
5. Radio mode
Select "Radio" on the FUNCTION sliding
switch.
5.1 Channel search
ڹ Chose a reception bandwidth. By pres-
sing the button BAND you can switch
between ...
• "FM" for VHF reception or
• "MW(AM)" for med. wave reception.
To search the bandwidth press the button ...
ൻ TUNINGį , to search forwards or
ർ TUNINGĬ , to search backwards over
the entire reception range.
If you apply pressure to the buttons for lon-
ger than a second the device will start an
automatic channel search. As soon as a
channel with sufficient reception quality has
been found, the automatic search stops
immediately.
Tip: When in VHF reception (FM) mode, you
will achieve better reception quality by put-
ting the antenna at an angle. Then turn the
antenna until the best reception is found.
For medium wave (AM) reception, the devi-
ce uses the internal antenna. Turn the entire
appliance until you achieve the best recepti-
on result.
5.2 Mono/Stereo
When a program is broadcast on the VHF
range in stereo, ST" is displayed on the devi-
ce, while MONO". appears for Mono broad-
casts. Should the stereo reception crackle
due to bad reception …
൹ press the ST/MONO button to switch
between the two modes.
5.3 Storing a channel
You can store a total of 15 channels. When
you have found a channel you would like to
store ...
ൺ press MEMORY . The display shows the
number of the first memory position, and
the "MEMORY" indicator flashes.
ൿ You can now browse through the
memory positions by pressing the
M-UP button.
KH2264_LB4_UK 17.11.2003 14:13 Uhr Seite 7