Kambrook Optimum Radiant Heater KRH600 - Manual (Page 2)

5
1
2
4
3
6
1. Convenient carry handles
2. Two heat settings and adjustable
thermostat
3. Convenient cord storage
4. High efficiency quartz element
5. Large castors
6. Neon ‘power on’ indicator light
Features of Kambrook Optimum Radiant Heater IMPORTANT PRECAUTIONS
When using electrical appliances, basic
precautions should always be followed,
including the following:
READ AND KEEP THESE
INSTRUCTIONS FOR FUTURE
REFERENCE BEFORE USING THIS
HEATER.
Keep combustible materials such as
drapes and other furnishing away from
heater.
The heater must NOT be located
immediately below a socket outlet.
Extreme caution is necessary when this
heater is used by or near children or
invalids.
Young children should be supervised to
ensure they do not play with the heater.
Do not operate heater whilst asleep.
Never operate the heater without safety
guards secured in position.
Important – this heater is intended for
floor use only. Do not mount on ceiling or
walls.
Do not leave heater unattended. Always
switch off the heater at the controls and
at the power outlet then unplug heater
from the power outlet when not in use.
Do not operate any heater with a
damaged cord or plug, or if heater has
been dropped or damaged in any manner.
Return heater to your nearest service
centre for examination, electrical or
mechanical adjustment or repair.
Do not use outdoors.This heater is not
intended for commercial use such as
construction sites.
This heater is not intended for use in wet
or moist locations. Do not use this
heater in the immediate surroundings of a
bath, a shower or a swimming pool. Do
not immerse or allow liquids to be spilt
on the heater.
Place unit well clear of heat sensitive
surfaces and where necessary place on a
suitable stable inflammable surface.
Do not run the cord under carpeting or
cover the cord with rugs, runners or the
like. Arrange cord away from traffic areas
and where it will not be tripped over.
To prevent a possible fire, allow ample
space around the heater (at least 1.7m at
front and 0.5m at the rear, top and sides)
and do not block air inlets or outlets in
any manner. Check the openings from
time to time for accumulated dust. Ensure
long shag carpet does not obstruct air
flow under unit.
To disconnect heater switch the control
setting to the OFF position, then switch off
at the power outlet prior to removing the
plug from its outlet.
Do not insert or allow foreign objects to
pass through the element guard as this
may cause an electric shock, fire or
damage the heater.
Do not touch hot metal surfaces.
Do not allow power cord to contact hot
metal surfaces. Do not operate heater
with the cord hanked or wound around
any part of the heater.
2 3