KTM EXC 200 XC DE - Manual (Page 10)

ENGLISH
9
Kilometers or miles
The unit (kilometers or miles) can also be changed. The ODO figure will be
retained and converted accordingly. The TR1, A1, S1, TR2 and A2 figures
will be cleared.
To select the unit, select the SPEED/H mode and hold the | button for 3 sec-
onds to access the SETUP menu. Press the | button until the KMH/MPH
function blinks. Press the + button briefly to move to the options. Press the
+ button for KMH or the – button for MPH.
To set, briefly press the | button 1 x and hold for 3 seconds until the dis-
play returns to the SPEED/H mode.
If no button is pressed for 20 seconds, the setting will be stored automati-
cally and the display will return to the SPEED/H mode.
+ button to access the menu
to activate the KMH display
– button to activate the MPH display
briefly press | button changes to the next mode
changes from the menu to the SETUP menu
hold | button 3 secs. stores and closes the SETUP menu
SPEED / A2 display mode (average speed 2)
A2 shows the average speed based on the TR2 (tripmaster 2) and S2 (stop
watch 2) figures.
The displayed figure can deviate from the actual average speed if the TR2
figure was changed manually or if S2 was not stopped after the trip.
+ button no function
– button no function
briefly press | button changes to the next display mode
hold | button 3 secs. changes to the next display mode
SPEED / S1 display mode (stop watch 1)
S1 shows the traveling time based on TR1 and continues to run whenever it
receives impulses from the wheel sensor. The calculation of this figure is acti-
vated by the first impulse received from the wheel sensor and stops 3 sec-
onds after the last impulse is received.
+ button no function
– button no function
briefly press | button changes to the next display mode
hold | button 3 secs. clears the TR1, S1, A1 figures
SPEED / S2 display mode (stop watch 2)
S2 is a manual stop watch. Start the stop watch by pressing the + button,
press again to hold. Press again to continue timing.
Press the | button to change to the next mode. The S2 display will blink in
the other modes if S2 continues to run in the background. To stop S2, return
to the SPEED/S2 mode and press the + button.
+ button starts and stops the stop watch
– button no function
briefly press | button changes to the next display mode
hold | button 3 secs. clears the S2 figure
OPERATION INSTRUMENTS
»