Kompernass TOUCH IT KH 4113 - Manual (Page 5)

- 3 -
• To switch it to the second brightness level: touch
the base 4 a second time.
• To switch it on to the third brightness level: Touch
the base 4 once again.
• To switch the table lamp off: touch the base 4
once again.
If you do not wish to use the table lamp for an ex-
tended period of time: Remove the power cable 5
from the power socket. To avoid damage, be care-
ful not to kink the power 5 cable.
9. Changing the light bulb
Should the bulb 1 in the table lamp be defect, it
must be exchanged for a new one. Additionally:
• Remove the power cable 5 of the table lamp
from the power socket.
If the table lamp was previously switched on: Allow
the lamp shade 2 and the light bulb 1 at least a
half-hour to cool down before you continue.
The risk of burns is ever present!
• KH 4112/KH 4114: Screw the light bulb 1 out
of the bulb holder 3 in an anti-clockwise direction.
• KH 4113: Loosen the covering cap 6. Careful-
ly remove the lampshade 2 upwards from the
table lamp. Then screw the old light bulb 1 out
of the bulb holder 3.
• Screw a new light bulb 1 into the bulb holder 3.
Use exclusively light bulbs of the type E14, 40 W.
• KH 4113: Replace the lampshade 2 onto the
table lamp. Secure it with the help of the cove-
ring cap 6.
• Insert the power cable 5 into a power socket.
The table lamp is once again ready for use.
10. Cleaning the table lamp
Before cleaning the table lamp, always remove its
power cable from the power socket.
Clean the table lamp exclusively with a slightly
damp cloth. Ensure that no moisture can permeate
into the lamp!
Otherwise, there is the great risk of
receiving an electric shock!
11. Troubleshooting
Problem
The table lamp does not function.
Possible causes / solutions
• Check to ensure that the power cable 5 is inser-
ted into a power socket.
• Check to see if the light bulb 1 of the table
lamp needs to be replaced. To do this, follow the
steps described in section 9. "Changing the light
bulb".
• Check to see if the power socket where the power
cord 5 is plugged in is "live". To do this,
connect another electrical device to the power
socket.
• Check to see if the fuse or circuit breaker for the
electrical circuit to which the table lamp is con-
nected has been broken/triggered.
Other defects
Contact one of our service partners in your area if …
• the listed functional defects cannot be corrected
as described or
• other functional defects arise.
IB_KH4112_14_33345_LB6 10.06.2009 14:42 Uhr Seite 3