Konica Minolta NS-42L550A11 - Manual (Page 24)

20
NS-32L550A11/NS-37L550A11/NS-42L550A11/NS-46L550A11 32"/37"/42"/46" LCD, 120 Hz
www.insigniaproducts.com
During auto channel search, your TV searches
for digital channels first. If you chose Antenna,
when the digital channel search is complete, a
message appears asking if you want to search
for analog channels. If you do not need to
search for analog channels, press MENU or EXIT
stop searching for channels.
When the scan is complete, the Setup Wizard
closes automatically.
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press (power) to turn on your TV. The power
indicator LED turns blue.
3 Press (power) again to turn off your TV. Your
TV enters Standby mode and the power
indicator LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The Source
List opens.
2 Press or to highlight a video input source,
then press OK/ENTER.
You can also press a direct input button to select
the video input source.
• Press TV to select TV.
• Press VIDEO to select AV.
• Press COMP to select Component.
• Press HDMI once to select HDMI 1.
• Press HDMI twice to select HDMI 2.
• Press HDMI three times to select HDMI 3.
• Press HDMI four times to select HDMI 4.
On-screen menu overview
Picture menu
Audio menu
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Warning
When your TV is in Standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
Note
If your TV does not receive an input signal for several
minutes, it automatically goes into Standby mode.
Note
If Auto Input Sensing is set to On, only the jacks that
have connected devices are active. The other inputs
are grayed and cannot be selected.
Source List
TV
AV
Component
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4
USB
MENU EXIT OK
ENTER
Picture
Mode
Brightness
Contrast
Color
Tint
PICTURE AUDIO CHANNELS SETTINGS USB
MOVE SELECT PREVIOUS EXIT
Adjust settings to affect picture quality
Energy Savings
50
48
70
0
0 s s e n p r a h S
MENU EXIT OK
ENTER
Audio
Audyssey Dynamic Volume
SRS TruSurround HD
Treble
Bass
Balance
PICTURE AUDIO CHANNELS SETTINGS
Digital Audio/SPDIF
MOVE SELECT PREVIOUS EXIT
Adjust settings to affect sound quality
Medium
Off
32
32
0
PCM
USB
NS-32_37_42_46_550A11_10-0465_MAN_V4_English.book Page 20 Friday, April 9, 2010 2:47 PM