Creating a song, Creating a song from scratch, Erasing song data (clear song) – KORG ELECTRIBER ER-1 User Manual

Page 34: Specifying a pattern for each position

Advertising
background image

34

5.Song mode

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Creating a song

Creating a song from scratch

Here's how to create a song by placing patterns in the desired
order.

If you switch to a different song while editing a song,
your edited data will be lost. If you wish to keep the
edited song, you must perform the Write operation to
save the song data.

Erasing song data (Clear Song)

1. If the song is playing, press the Stop/Cancel key to stop play-

back. Then select the song that you wish to erase.

2. Hold down the Shift key and press step key 16 (Clear Song).

(Key 16 will blink.)

3. Press step key 16 once again to erase the song data.

To cancel, press the Stop/Cancel key.

If you erase the song data by mistake, rotate the dial to re-select
the song before you save it. This will restore the data to its origi-
nal condition.

2,3

2

Specifying a pattern for each position

Position

001...256

Pattern

A01...d64

Here's how to specify the pattern for each position.

1. Use the cursor keys to make the parameter select LEDs indi-

cate Position. Notice that the display indicates "001."

2. Use the cursor keys to make the parameter select LEDs indi-

cate Pattern.

3. Rotate the dial to select the pattern that you wish to assign to

position "001."

4. Press the select [

] key to advance to the next position. The

display will indicate "End."

5. Rotate the dial to select the pattern. The pattern you select

here will be the pattern for position "002."

6. When you select a pattern for the "End" position, the "End"

will move to the next position. Repeat steps 4 and 5 to assign
as many patterns as you wish.

To playback the completed song from the beginning, press the
Play/Pause key once, and then press the Stop/Cancel key. Al-
ternatively, use the cursor keys to make the parameter select
LEDs indicate Position, and rotate the dial or use the select keys
to set the position to "001." Then press the Play/Pause key.

3,5,6

1,2

4,6

If you wish to view the order of patterns in the song, or to re-
select the pattern for a specific position, make the parameter
select LEDs indicate Pattern. Each time you press a select key,
you will move to the next or previous position. You can use the
dial to change the pattern number that is displayed.

Pattern

Use the select keys to move through the positions,
and use the dial to select patterns

Alternatively, you can make the parameter select LEDs indi-
cate Position, and use the dial or select key to select the position
you wish to check. Then make the parameter select LEDs indi-
cate Pattern, and view or change the pattern.

Pattern

Position

At the Position setting use the select keys or dial to move;
then select Pattern and use the dial to select or view the pattern.

Advertising