KORG ELECTRIBER ER-1 - Manual (Page 37)

37
5.Song mode
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
5.Song mode
Deleting event data from a song
(Clear Event)
This operation deletes all event data from the selected song.
1. If the song is playing, press the Stop/Cancel key to stop play-
back.
2. Hold down the Shift key and press step key 15 (Clear Event).
(The 15 key will blink.)
3. Press step key 15 once again to clear the data.
To cancel, press the Stop/Cancel key.
2,3
2
Checking for song event data
If event data has been recorded in a song, holding down the
Shift key and pressing the Motion Sequence key will make step
keys 13 through 16 light.
It is not possible to check for event data during play-
back or recording.
Saving a song (Write)
If you wish to save a song that you create, you must perform
this Write operation.
If you decide not to save the song data you create, simply switch
songs without performing the Write operation.
1. If the song is playing, press the Stop/Cancel key to stop play-
back. Use the cursor keys to make the parameter select LEDs
indicate Song.
2. Press the Write key once (the key will blink). The song num-
ber will blink in the display.
3. Rotate the dial to select the writing destination song number.
4. Press the Write key once again to save the data. (The key will
light, and then go dark.)
To cancel, press the Stop/Cancel key.
3
2,4
If the Global mode Memory Protect setting is on, it will
not be possible to write the data. In this case, turn off
the Global mode Memory Protect setting before you ex-
ecute the Write operation.
Never turn the power off during the Write operation. This
may damage the data.