Kenwood KTC-H2A1 - Manual (Page 17)

1. While in the Setup Mode, press the left or right arrow
button until the Audible Alert screen appears (right):
2. Use the up & down arrow buttons to turn the audible
alert ‘beep’ on or off.
Antenna Signal
This screen shows the quality of the SIRIUS satellite
signal that’s being received, to help you find the best location for the antenna.
1. While in the Setup Mode, press the left or right arrow
button until the Antenna Signal screen appears (right):
• After a few seconds the signal quality bars will indi-
cate how well the antenna is receiving the
SIRIUS satellite signal.
2. Find a location for the antenna that illuminates the
maximum number of bars.
• After moving the antenna, wait at least 2 seconds before moving it again, to enable the unit to process
the signal.
3. Due to the moving paths of the SIRIUS satellites, it is possible for the signal to change over time. In most cases,
signal should be available continuously, however, it may be temporarily blocked in some antenna locations in home
installations. Be sure to check the the Antenna Signal screen if there is a loss of signal or audio. Experimentation
with antenna placement in the home or outside may be necessary to ensure continuous reception.
• See pages 11–13 for information about properly locating the SIRIUS antenna in a home installation.
Here
2
Anywhere Instruction Manual (ver. 2)
33
Text Flow Type
You can set how the scrolling text flows across Here
2
Anywhere’s screen.
1. While in the Setup Mode, press the left or right arrow
button until the Text Flow Type screen appears (right):
2. Use the up & down arrow buttons to select the type
of text flow.
• In the DISCRETE mode the text moves across the
screen in steps
• In the CONTINUOUS mode the text moves across the screen smoothly.
Output Level
You can adjust Here
2
Anywhere’s output level so it matches other sources in your audio system.
1. While in the Setup Mode, press the left or right arrow
button until the Output Level screen appears (right):
2. Use the up & down arrow buttons to select the
desired output level.
• “High” is 0dB, “Medium” is –3dB and “Low” is –6dB.
Note: To avoid distortion with some cassette car stere-
os, you may have to lower the output level when using the cassette adapter.
Audible Alert
You can turn Here
2
Anywhere’s Song Seek and Auto Shutoff alert beep on or off (see pages 23 & 28).
Here
2
Anywhere Instruction Manual (ver. 2)
32
Antenna Signal Screen
Audible Alert Screen
Text Flow Type Screen
Output Level Screen