Krown Manufacturing K-EQ40 - Manual (Page 7)

THE EQUALIZER FEATURES
1. Volume Control
Slide the HANDSET VOLUME (it is located on the right side of the base) to
a comfortable listening level.
2. Ringer Volume Control
Set the ringer volume, located on the right side, by sliding RINGER to HI
(high) to amplify the ringer, or to LO (low) for a softer ring. To turn off the
ringer, set it to OFF. You can still make and receive calls with the ringer off.
3. Ringer Pitch Control
To adjust the pitch of the ringer set PITCH to 1 (low frequency), 2 (medium
frequency), or 3 (high frequency) located on the right side of the base..
4. Tone Pulse Control Switch
Set TONE/PULSE, located on the right side of the base to TONE (tone) or
PULSE (pulse) to match the type of service you have.
5. Ringer Indicator
The red ring indicator, located in the top right corner will flash when the
phone rings. It will flash even if the ringer is turned off.
6. Redial / Pause
Press REDIAL to dial the last number dialed (up to a 32 digit number). This
button is also used to insert a pause into a string of number stored in memory.
7. Flash
Press FLASH to perform the switchhook operation for special services, such
as Call Waiting. If you do not currently have that service with your local
telephone company, pressing FLASH may disconnect your call. To obtain
this service, contact your local telephone company for subscription
information regarding this service.
Note: The redial memory does not store a FLASH entry or any digits entered before
you press FLASH.
8. Using the equalizer
The phoneʼs 3-band equalizer boosts the
sound of three frequency ranges (600 Hz,
1.2 kHz, 2.4 kHz) to compensate for the earʼs
limited sensitivity in these ranges. To adjust
the settings, open the cover next to the
EQUALIZER button (it reads Krown
Manufacturing). Slide each switch toward
“+” to increase or amplify sound, or toward
“-” to decrease the sound within that specific range.
600Hz 1.2kHz 2.4kHz
Figure 5
5