Kathrein DVB Cable Receiver UFC 662sw - Manual (Page 11)

11
CONNECTION AND SETUP
The following section is intended specifi cally for specialist dealers. You need not refer to this section
unless you are carrying out the installation yourself.
The “Connection examples” section provides a sample confi guration.
Do not connect the receiver to the power supply until all installation work has been properly carried out.
Refer to the information in the “Safety instructions” section.
When fi tting the connector, make sure that no wires from the braid are touching
the inner conductor, otherwise a short circuit will occur.
The quality of the reception signal depends on this connection!
CONNECTING THE RECEIVER
The serial number sticker for the UFC 662sw is located on the underside of the unit.
The information printed on it includes the following:
- the exact designation (e.g. UFC 662sw)
- the part number and
- the serial number of the unit.
You do not need this information in order to operate the unit. If however, contrary to
expectations, you need to make a claim under warranty and you do not have the packaging
for the receiver to hand, you can fi nd the above information about the unit on this sticker.
Connect the RF input of the receiver to the antenna socket. For this, use a coaxial cable
with a plug to with the F standard or the IEC standard (in combination with the F adapter
supplied with the receiver).
If the IEC connector is not yet fi tted to the cable, strip the insulation from the cable as
shown in the following illustration and carefully fi t the connector on to the end of the cable
so that it is securely fi tted.
Fitting a plug to the
“F” standard
Fitting a plug to the
“IEC” standard
Lengthwise slits (3x) Bend back Screw together